Q&T hardness of the three grades
Grade 45 (GB/T 699-2015), Q&T: surface hardness HRC25–28 or HRC28–32, chosen per order. Grade 45 has limited hardenability, so the core is softer than the surface and core hardness is not guaranteed.
40Cr (GB/T 3077-2015): Q&T hardness HRC28–35. 42CrMo (GB/T 3077-2015): Q&T hardness HRC30–38. All three are Q&T bases with hard chrome on top; plating is done by long-term partner plants to Yixin's specification.
Published sample results
Complete reports on sample bars tested in July 2026 are on our Quality page; results apply to the tested samples only. Jiangsu Yinshi Inspection & Testing, report 2026-YS-26070183118-1, 45 steel Q&T ground bar sample: surface HV10 292.6 / 297.2 / 298.3 (about HRC 29), core HRC 21.6 / 22.0 / 21.9, Rm 863 MPa.
Same laboratory, report 2026-YS-26070183118-2, 40Cr Q&T ground bar sample: core HRC 34.8 / 35.1 / 35.6, Rm 1051 MPa, Rp0.2 920 MPa. Read together, the two reports show the softer core of grade 45 and the better hardenability of 40Cr. There is no published report for 42CrMo yet.
How to choose
Steady load, ends still to be machined: 45 steel Q&T chrome-plated bar. A harder wear surface that resists knocks: 45 steel induction-hardened chrome shaft (case at least HRC55, effective case depth about 2 mm).
Drawing specifies 40Cr, or the load needs a stronger Q&T base than grade 45: 40Cr Q&T chrome-plated bar, Ø8–140 mm, made to order. Heavy or shock loads needing a 42CrMo base: 42CrMo Q&T chrome-plated bar, Ø8–100 mm, made to order from 1 tonne in 7–10 days, plus the time to book the vessel.
When alloy steel is not needed
Buckling of a rod depends mainly on diameter and length, not on the grade. If a slender rod bends, check the diameter before changing the steel.
If the drawing names a foreign grade such as 42CrMo4 or SCM440, these are comparable grades, for reference only. Supplying to the GB grade needs written acceptance from the designer or buyer. The heat analysis is on the steel mill certificate, which is forwarded unaltered.

