01

Start with what runs on the rod

The balls of a linear bearing roll on the shaft in point contact, and a soft surface can groove under them. That is why these rods are induction hardened before hard chrome plating. Yixin's 45 steel induction-hardened chrome shaft and chrome-plated linear shaft have an induction-hardened case of at least HRC55 with an effective case depth of about 2 mm. The linear shaft comes in Ø4–130 mm; the hard shaft in Ø4–130 mm as standard, up to Ø200 mm made to order.

Bushings (nylon, bronze, self-lubricating materials) run in surface contact and ask less of the shaft surface. Under light load, a 45 steel chrome-plated soft shaft — not induction hardened, base about HRC17 — is usually enough, and it can still be turned, milled or drilled after supply.

02

Tolerance, straightness and chrome

For linear bearings, the chrome-plated linear shaft is usually 0/−0.02 mm from Ø12, and −0.02/−0.05 mm for Ø4–11; other tolerances are assessed from the drawing. Typical straightness is about 0.1 mm/m above Ø25 and about 0.2 mm/m below Ø25. For long rods, write the straightness over the full length on the drawing.

Hard chrome is 10–50 μm per side, chosen per order, with Ra ≤ 0.4 μm on the chrome surface. Indoor equipment rarely needs a thick layer. Where a corrosion rating is required, we specify a thicker chrome layer and can have the order tested by a third-party laboratory.

03

Length and ends

Full bars are 4 m, 6 m, 7.5 m or 8.1 m. From 200 mm, bars are CNC saw cut to length with about 3 mm allowance, ends left as sawn. Drilled and tapped ends and chamfers, common on guide rods, are done by long-term partner plants to Yixin's specification and assessed from your drawing.

The surface of an induction-hardened shaft is already hard. If the ends need threads or holes, give the positions and sizes in the RFQ so the machining sequence can be planned.

04

When we are not the right supplier

Export orders start at 1 tonne (sizes can be combined). If you need a few replacement rods, a local parts dealer is the better choice. We do not make stainless steel or hollow tube guide rods: our materials are solid bars in grade 45, 40Cr and 42CrMo.

To test first, we can supply a 20–50 kg sample. Samples are charged, the sample fee is refunded with the production order, and freight is paid by the buyer.