How the two differ
A chrome-plated shaft has a carbon or alloy steel base with hard chrome on the surface. Yixin's hard chrome is 10–50 μm per side, chosen per order; chrome hardness can reach HV800+ and the chrome surface is Ra ≤ 0.4 μm. Both wear resistance and rust protection come from that layer.
A stainless steel shaft resists corrosion through the whole section, including surfaces newly exposed by cutting, drilling or turning. Corrosion resistance and hardness differ widely between stainless grades, so choose by the medium and the stainless supplier's data.
Where chrome-plated shafts fit
Hydraulic and pneumatic piston rods, linear guide shafts, guide pillars, and guides in conveying and packaging machines: these need a hard, low-friction surface and stable size. For more wear resistance and resistance to knocks, choose the induction-hardened chrome shaft (case at least HRC55, effective case depth about 2 mm).
Where a corrosion rating is required, we specify a thicker chrome layer and can have the order tested by a third-party laboratory. Salt-spray performance is not part of the standard specification.
What to watch with chrome
Ends cut to length are left as sawn and have no chrome. Areas turned, drilled or tapped after supply also expose the base steel. Protect them with oil, paint or by design.
Where the chrome is dented or scratched through, the base steel can rust from that spot. This is why finished bars are packed without steel straps; avoid knocks in handling and storage as well.
When stainless steel is the right choice
Long contact with water, sea water, cleaning and disinfecting fluids or chemicals; food and pharmaceutical uses with hygiene requirements for the material; parts with many machined surfaces that cannot each be protected.
For these, use a stainless shaft supplier. Yixin does not offer stainless steel or bearing steel as products.

